The WI-210 is a slim panel mount weighing indicator that feeds a PLC a 4-20 mA signal proportional to weight. A 96 by 48 millimetre bezel, backlit LCD, four membrane keys and simple two point calibration suit OEM machines, dosing controls and tank weighing panels where a full featured terminal is unnecessary.
Many machines only need weight as another analog process variable, not a full operator console. The WI-210 is designed for exactly that role: it excites a load cell, converts the signal and retransmits the result as a 4 to 20 milliamp current that any PLC analog card can read. The small front panel still gives local visibility and access to tare and calibration, so commissioning technicians can work without a laptop. Its compact footprint saves space in densely packed control cabinets.

A 96 by 48 millimetre black aluminum bezel holds a backlit LCD with a six digit weight field and small status icons. Four membrane keys provide zero, tare, set and enter functions, and the gasketed front meets IP65 when installed with the supplied clamp. The rear terminal block carries excitation, signal, current output and 24 volt DC power, with reverse polarity protection on all connections. The shallow body depth leaves room behind the panel for wiring ducts.
The analog retransmission is scaled freely between zero and full capacity, with 16 bit resolution and an update rate near 50 readings per second. Accuracy of the analog chain is better than 0.1 percent of full scale, and the load cell input accepts 1 to 2 mV/V sensors with four or six wire cabling. Zero tracking, a motion detection window and selectable digital filtering keep the current loop steady on vibrating machinery. Calibration data is retained through power cycles.
Cut the panel opening to the specified dimension and tighten the two mounting clamps evenly so the gasket seals without distorting the bezel. Connect the 24 volt supply and the current loop with correct polarity, and use a separate shielded pair for the load cell signal. Set the analog zero and span after a two point weight calibration, then verify the loop current at mid scale with a meter. Keep the front film in place during panel assembly.
A mounting clamp set, gasket, terminal plug and quick calibration guide are included. The current loop scaling and display units can be preset at the factory for repeat OEM builds, and a printed front label with a custom legend is available. A matching 24 volt power supply and a small junction box can be ordered together. Units are individually tested with a simulated load cell before packing.
Send Inquiry
You Might Also Like