PT-10 Compact Pressure Transducer 0-10 bar

The PT-10 is a compact pressure transducer covering 0 to 10 bar gauge pressure for compressors, pumps, hydraulic units and building services. A stainless steel diaphragm, G1/4 process thread and selectable 4-20 mA, 0-10 V or ratiometric output make it an easy drop in sensor for control panels and monitoring systems.

Product Introduction

General purpose pressure monitoring needs a sensor that is small, electrically forgiving and tolerant of vibration. The PT-10 uses a welded stainless steel diaphragm coupled to a piezoresistive element, with the signal conditioning built into the same housing, so a long cable can run straight to a PLC analog input without an external amplifier. It suits water, air and light hydraulic oils, and the standard process thread means existing pipework rarely needs an adapter during retrofit projects.

PT-10 product view 1

Construction and materials

All wetted parts are 316L stainless steel with no internal O-ring in the standard version, which removes a common leak path and improves media compatibility. The hexagonal body carries a G1/4 male thread and a hex key flat for torque controlled installation, while the upper section holds the ceramic carrier and the potted electronics. A moulded circular connector or a two metre shielded cable provides the electrical interface, and the housing is rated to IP65 with a breather tube inside the cable jacket.

Performance and calibration

The 0 to 10 bar range is delivered as 4 to 20 milliamps, 0 to 10 volts or a ratiometric 0.5 to 4.5 volt signal, with total error including non-linearity, hysteresis and thermal effects below 0.5 percent of full scale. Overpressure reaches 1.5 times the range and burst pressure three times. Response time is under two milliseconds, so pump pulsations are visible, and the compensated temperature band spans minus 20 to plus 85 degrees Celsius. Reverse polarity and short circuit protection are built in.

Typical applications

  • Compressor and compressed air receiver monitoring
  • Water pump, booster set and irrigation control
  • Hydraulic power units and filter clog detection
  • Heating, ventilation and building automation systems
  • Test benches and general industrial pressure logging

Installation and integration

Seal the process thread with a suitable gasket or thread sealant applied only to the male thread, and tighten by the hexagon rather than the housing. Fit a snubber if pressure spikes or water hammer are expected, and mount the sensor with the diaphragm pointing slightly downward so air pockets cannot trap. Use a separate ground for the cable shield, avoid running it beside variable frequency drive wiring, and verify the zero reading with the system vented to atmosphere.

Technical summary

  • Measuring range 0 to 10 bar gauge, other ranges available
  • Total error below 0.5 percent FS, response under 2 ms
  • Outputs 4 to 20 mA, 0 to 10 V or 0.5 to 4.5 V ratiometric
  • 316L stainless wetted parts, G1/4 male process thread
  • Protection class IP65, overpressure 1.5 times range

Ordering and delivery

A calibration certificate at three pressure points, a connector pinout sheet and a protective cap are included with each unit. Output type, pressure unit, connector style and cable length are selected at order entry because the electronics are configured before potting. Alternative process threads and flush diaphragm versions can be quoted for viscous media. Multi unit orders can be supplied with matched span values for comparative monitoring.

Send Inquiry

You Might Also Like